Select a Category
Build Author quyngan Views 1165
DIY LED acrylic lamp
This is a simple lamp using only 2 LEDs & 2 AAA batteries.
Build Author Robert Huxford Views 842
High Intensity Dive Light
Long duration , high intensity SCUBA dive light using Li-Po 18650 batteries and advanced circuitry.
Build Author Anthony Bolgar Views 2834
Spindle cooling setup
Cooling system for water cooled spindle.
Build Author Gerrald Views 2053
This build is to show what's possible as well with openBuilds! I use a single ArduinoMega and 5 separate stepper drivers (A4988). The LEDs are all NeoPixels. Collision 'detection' is all done within the code, so the endstops are only sensors I use in this build. I'm a self-employed video-artist and this is my first installation which just needs power and it runs (where I'm quite proud of). Normally my interactive installations take a long setup time, so this installation is a relief :)
Build Author Dave420 Views 3318
Dave's Z axis and powder coated.
I just did my first Powder coat paint job on a Z Axis with 9inchs of travel for the DIY CNC Plasma Cutter, Mill Head, Router, Engraver, Laser Head, Water Jet Cutter Machine. 2 different Z Axis ride plates and a 80mm Router/Mill Head/Spindle clamp. Baked on finish in a old oven i had.
Build Author Skoobs Views 2447
Pretty Standard + Slave X Axis
Planning my build, just looking for design input at the moment. I definitely want a slave X axis. I am potentially going to go with one of the 1500W Chinese water cooled spindles.