Welcome to Our Community

Some features disabled for guests. Register Today.

control software question

Discussion in 'Other Software' started by GrandpawB, May 9, 2015.

  1. GrandpawB

    GrandpawB Well-Known
    Builder

    Joined:
    Dec 23, 2013
    Messages:
    122
    Likes Received:
    3
    Does anyone know of a control software program that will use Windows 7 installed on a laptop to control my CNC router? I currently am using Mach3 on a Win XP desktop and it's so very slow it drives me crazy.
     
  2. Joe Santarsiero

    Joe Santarsiero OB addict
    Staff Member Moderator Builder

    Joined:
    Oct 30, 2014
    Messages:
    902
    Likes Received:
    196
    Mach3 will run on a windows 7 laptop. I use it on a win7 64bit laptop with a warp9 ethernet smoothstepper.

    There are a lot of people that run it on XP just fine. Try a fresh install of XP. Should be faster after.
     
  3. GrandpawB

    GrandpawB Well-Known
    Builder

    Joined:
    Dec 23, 2013
    Messages:
    122
    Likes Received:
    3
    Thank you. I did a little research on the web about this SmoothStepper you mentioned. Sounds like what I need. Next question-Would anyone reading this happen to have a photo or drawing of a Geckodrive G540 connected to an Ethernet SmoothStepper? I've checked the Internet and have come up empty.
     
  4. Joe Santarsiero

    Joe Santarsiero OB addict
    Staff Member Moderator Builder

    Joined:
    Oct 30, 2014
    Messages:
    902
    Likes Received:
    196
    You need a 26pin to a db25 connector.
    the db25 connects to the g540 and the 26pin to port 1 on the smoothstepper.
    the smoothstepper then connects to the ethernet or usb port on the laptop.

    The smoothstepper isnt exactly the cheapest route though.
    I think its been mentioned here before that one can find a used desktop with a db25 parallel port for less than the cost of a smoothstepper. I purchased a warp9 ESS and cable for somewhere to the tune of $200US. Its not unreasonable to find a used desktop for that price on ebay.

    This cable I purchased seperatly from amazon. The shipping time was long. If you go the route of ess then order the cable together.
     

    Attached Files:

  5. GrandpawB

    GrandpawB Well-Known
    Builder

    Joined:
    Dec 23, 2013
    Messages:
    122
    Likes Received:
    3

    Thank you. Huge help. :)
     
  6. GrandpawB

    GrandpawB Well-Known
    Builder

    Joined:
    Dec 23, 2013
    Messages:
    122
    Likes Received:
    3
    I got my ethernet Smoothstepper today. Trying to connect it to a spare Windows 7 laptop and my Geckodrive G540. What a nightmare. I'm not a networking guy (I'm a woodworking guy) so I don't understand all this IP address, Gateway stuff. I've been reading the install instructions online and most of it I don't understand. Could someone please help me with this configuration?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice