Welcome to Our Community

Some features disabled for guests. Register Today.

Cutting extrusion

Discussion in 'General Talk' started by DarkAlchemist, Sep 16, 2015.

  1. DarkAlchemist

    DarkAlchemist Well-Known
    Builder

    Joined:
    Aug 2, 2014
    Messages:
    401
    Likes Received:
    22
    I have a 24t hacksaw and tried some flat plate and it was ugly. 32t I will buy but should the blade be backwards and cut only in one direction and not as if you were sawing down a tree? I will use a miter box and the hacksaw as I don't have the room for a chop saw and cutting aluminum is very easy by hand as long as I have (I didn't with the flat plate) something to keep my cut straight (hence the miter box).

    I am about to start with my printer build so trying to get everything working in my head and I hope all of it will be done by the second anniversary of having built the boat anchor of a printer I have now.
     
    #1 DarkAlchemist, Sep 16, 2015
    Last edited: Sep 16, 2015
  2. Adam Filipowicz

    Adam Filipowicz Journeyman
    Builder

    Joined:
    Dec 21, 2014
    Messages:
    259
    Likes Received:
    129
    Mitre saw with blade made to cut aluminum
     
  3. DarkAlchemist

    DarkAlchemist Well-Known
    Builder

    Joined:
    Aug 2, 2014
    Messages:
    401
    Likes Received:
    22
    Same deal as a chop saw and that was already brought up as a no.

    Back to the unanswered question of "which is better to cut with a 32 tooth hacksaw blade having the teeth going backwards or frontwards"?
     
  4. Joe Santarsiero

    Joe Santarsiero OB addict
    Staff Member Moderator Builder

    Joined:
    Oct 30, 2014
    Messages:
    902
    Likes Received:
    196
    32t frontwards. Cut on the push not the pull. A good rule of thumb for blade selection is 3 teeth in a row in contact with the work. You may not get that with cutting extrusion, but the finer blade should do okay.

    Joe
     
  5. DarkAlchemist

    DarkAlchemist Well-Known
    Builder

    Joined:
    Aug 2, 2014
    Messages:
    401
    Likes Received:
    22
    Ahhh, half of what I was thinking after cutting the aluminum plate with the 24t. I figured the cut on the push then pull it up on the pull and back down on the push to cut again but I was thinking the teeth towards me so I got that part wrong.

    I don't quite get that part about 3 teeth in a row in contact with the work. Any pictures or links I can study?

    edit: I know a nice 60 dollar Diablo 84t blade made for non-ferrous metals on a 10inch chop saw/miter saw makes it short work but you use what you have and I am only going to cut 6 times so not counting the lack of room here I would have no other uses for the huge beast.
     
    #5 DarkAlchemist, Sep 18, 2015
    Last edited: Sep 18, 2015

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice