Welcome to Our Community

Some features disabled for guests. Register Today.

Aluminum Ox

Discussion in 'CNC Mills/Routers' started by richthorn, Mar 15, 2014.

  1. richthorn

    richthorn New
    Builder

    Joined:
    Feb 10, 2014
    Messages:
    5
    Likes Received:
    5
    richthorn published a new build:

    Read more about this build...
     
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,742
    Likes Received:
    2,407
    Well done Richthorn! Looks like you have the speeds dial in on this OX.
    What are you using for the controller? EDIT: I see your using the Gecko G540 nice!
    Keep up the good work
    p.s. gave you 5 star rating but spelled your name Richard sorry about that ;)
     
  3. richthorn

    richthorn New
    Builder

    Joined:
    Feb 10, 2014
    Messages:
    5
    Likes Received:
    5
    Well it is my name so we won't fault you :thumbsup:

    I'm using a Gecko G540 and some 380oz/in motors. The company I ordered from had some more powerful motors but they were 3/8" shaft and wouldn't work with the pulleys so I went with these guys but I'm not complaining. Should be a seriously capable machine once I slow it down a bit on the feedrate for cutting.
     
  4. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,742
    Likes Received:
    2,407
    they are more then enough for sure!:thumbsup: Sounds like a great setup for this machine, looking forward to your first cuts. :)
     
  5. richthorn

    richthorn New
    Builder

    Joined:
    Feb 10, 2014
    Messages:
    5
    Likes Received:
    5
    Just tested the X-Axis at 1000IPM and it didn't miss a single step. Quite the machine you designed :thumbsup:
     
    Mark Carew likes this.
  6. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,742
    Likes Received:
    2,407
    Thanks @richthorn :thumbsup: Glad your liking it and I hope it brings you as much fun as it does for me!
     
  7. brjig

    brjig New
    Builder

    Joined:
    May 22, 2014
    Messages:
    15
    Likes Received:
    6
    What mounting plates are you using for the z-axis motor?
     
  8. SlowBipe

    SlowBipe New
    Builder

    Joined:
    Jan 28, 2014
    Messages:
    19
    Likes Received:
    14
    Can you tell me with specific steppers you used with this build and where you bought them? Also wondering where you picked up your 18 tooth pulley's for the drives?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice