Welcome to Our Community

Some features disabled for guests. Register Today.

limit-homing

Discussion in 'General Electronics' started by peter28, Oct 7, 2016.

Tags:
  1. peter28

    peter28 New
    Builder

    Joined:
    Sep 9, 2016
    Messages:
    22
    Likes Received:
    4
    Hello,

    I was just wondering , when i buy my ox( i will make a lot of cabinet sides etc )

    if i place limit switches can i use these also to home my machine so that everytime my X,Y, Z axes ar always in the same spot before a job even if the power goes out or i set the machine of.

    then when i start up the machine again i set it to 0 X ,0 Y, 0 Z and its always the same position ,this
    is very important to me for drilling cabinet holes they must be every time at the same position.
     
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,742
    Likes Received:
    2,407
    Correct this is how this works. You can also use these as your home switches and have offsets setup for different material positions you use a lot.
    Hope this helps
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice