Welcome to Our Community

Some features disabled for guests. Register Today.

Climb milling with sketchucam

Discussion in 'CAD' started by Frederic Goddeeris, Oct 11, 2014.

  1. Frederic Goddeeris

    Builder

    Joined:
    Jul 15, 2014
    Messages:
    39
    Likes Received:
    19
    I am a bit confused about the use_pocket_cw and use_plunge_cw settings. They seem to be related to climb milling, but do not seem (and the name suggests that) to influence the direction of the inside and outside cuts.
    Can I do climb milling with sketchucam?

    Thanks,
    Frederic
     
  2. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Aug 6, 2013
    Messages:
    3,239
    Likes Received:
    1,815
    POCKET and PLUNGE they say, and that is what they affect (-:
    inside and outside direction is affected by the 'overhead gantry' setting, so try that both ways.
     
  3. Frederic Goddeeris

    Builder

    Joined:
    Jul 15, 2014
    Messages:
    39
    Likes Received:
    19
    Indeed, that works, thanks :thumbsup:
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice