Separate names with a comma.
Some features disabled for guests. Register Today.
I had a similar problem with the units measurement. Have always used metric so didn't notice when the program opened and had switched itself to...
No I hadn't. thanks for the reminder.
My machine stopped in the middle of executing a program. Error message I get: PORT ERROR: Writing to COM port(GetOverLappingResult): Unknown error...
Thank You
Trying to setup a command button to check the Z axis is moving the prescribed amount. Here's the code; G91G21 G0Z10.0; G0X50.0Y50.0; G1Z-5.0F300;...
Thanks everyone.
Are there grbl compatible boards other than the UNO with more flash memory?? Apparently grbl uses 92% of the UNO's memory and triggers a warning...
Thanks.
Hate to ask such a basic question, but; My CNC is grbl controlled installed on an UNO. When I download a Gcode file from Vectric to my Open Builds...
Thanks for responding. When cutting acrylic we ran an Amana 51411K "O" flute at 450mm/m and 12K RPM and it does a good job. We tried Amana's...
So it turned out to be the acceleration rate was too high. Cut it in half and everyone's happy.
Setting up to use an AMANA V bit to engrave acrylic. Amana recommends 18K RPM and 90"IPM (or 2286mm/m) for this bit. Depth of cut is .2mm. Lead...
Planning to build a larger (24" x 24") machine and would like to upgrade to ball screws. Problem is, any I see on Amazon at a price I would pay,...
