Separate names with a comma.
Some features disabled for guests. Register Today.
Unfortunately, we are back to waiting to connect to wifi on boot again. Is there anything I can provide that will help isolate and resolve this issue?
Thanks Peter, I was able to get it erased and reflashed, flashed to 1.52 again. Booted it back up, configured the ap settings and it appears to...
Not sure what's going on, but my interface will not boot past step 4/7 wifi connecting. Was able to flash it via bootloader mode to 1.52, but no...
Thanks Peter! Looking forward to putting this mod on as part of the initial build.
I was looking for the High Z mod for the 1515 as well, can someone confirm this will work on the 1515?
If memory serves me, 30mm/s is about the limit for flexible filaments. But it's been a while since I've done any. Here's a video of my C-Bot...
Ditto for me. NinjaFlex and TPU works great with the Titan.
IMHO - If you are trying to do a direct drive using the small 18 netwon meter steppers, I don't believe it will work reliably. Those small torque...
FWIW - I run Kysan steppers almost everywhere except for my Titan extruder, similar in setup to Carl's Direct Drive. Movement Steppers - Kysan -...
Do you have a titan extruder by chance? Or are you looking to use Carl's Direct Drive?
Are you tensioning the belts when the motors / controller is on? Sounds like the slack is not been taken up during the tensioning. It would help...
FYI - For anyone looking into this project that may not be aware, it's still very much alive and well as this forum, so feel free to post a...
I rarely re-level it now. Only when I swap in a large glass sheet I use to increase the build platform size to support large customer jobs. But...
I went with the nice knurled nuts with stiff springs as well. I can corroborate that they work well and don't loosen up. Makes leveling so much...
