Separate names with a comma.
Some features disabled for guests. Register Today.
Worked great. One less thing to worry before running a job :thumbsup:
I had to add more lines as below, since it got rid of M5 , M2 and move to (0,0,.8) from GCODE, when I added the footer begin FOOTER "M9" "M5"...
Yes, it takes a few seconds for the dust collector to fully start sucking air. I'll move it before G0. I guess the M9 at the footer loks good too?...
Looks good? +--------------------------------------------------- + Commands output at the start of the file...
THank Thanks. I'll try this.
Sorry. I should've mentioned earlier. I was sending the code from Vectric pro (with Openbuilds post processor profile)
@Peter Van Der Walt This morning I connected a 2nd IOT relay for the dust collector (1st one for Dewalt 611) to the blackbox 'Cool' port. Also...
@Peter Van Der Walt @OpenBuilds Any idea why I am getting this error on INTERFACE. Happened 3 times today that ruined my projects and...
I have 1.24 installed, but not the latest.
@Peter Van Der Walt This is all I've got while trying to connect to INTERFACE remotely within the same WIFI network. What I am doing wrong? The...
I will definitely try this.. Thanks for the instruction.
Thank. Have you or anyone tried 'over the internet' file transfer to INTERFACE so far? @Peter Van Der Walt Is it something we can do? If so,...
I will get a 2nd IOT instead if that's safer to do...Thanks!
@OpenBuilds Can I use same IOT relay for driving both Deawlt 611 router and Bucktool 1HP 6.5 Amp dust collector ? Both connected to each...
