Separate names with a comma.
Some features disabled for guests. Register Today.
G Code up and running [MEDIA]
There actually is quite a bit of side support inside [ATTACH] I cant image the spool ( even completely empty ) just hopping over a 2cm ledge.
While not being able to work on x / y i made the spool holder / Filament drive assembly: [ATTACH] [ATTACH]
It could atleast print standard kitchen cabinets :D Just sliced one example model in vase mode, the times arent to bad, this thing Twisted...
Goddamit ! Just mounted the Y axis, tested how the axles work together - realised i ordered only 2 meters gt2 belt instead of 4, so no gcode...
Got the X axis up and running, from what ive seen so far i might Gzero @ about 3000mm/m which is okayish for now, maybe i can go a bit further...
Ive got the Table assembly up and running today ! Firmware wise it was really easy once again, Marlin is prepared to slave the second extruder...
Hey david, you can just buy them fortunatly ;) i bought the longest ones i could find at about 800mm to get the rods spaced apart as far as possible.
Getting X / Y to work will take a little longer because i needed to refine some of my drawings after realising that bearings with 24mm outer...
A little update here: First i drilled all the holes for mounting the linear guides and then mounted them by simply screwing all the way through...
Redrew and printed the holders for the brass trapezoidal nuts. [ATTACH] [ATTACH] Almost done ! [ATTACH]
Very nice looking machine ! Where did u get all the sheet metal work done ? What kind of stepper drivers are you using right now ? What pitch...
I printed some small blocks with two bearings which will later hold the trapezoidal spindle which in turn moves the bed assembly: [ATTACH] All...
I needed to cut down the supports from my supported Rails in the workshop ( China at its finest, 1001mm instead on 1000 ;) rails seem fine though...
Hey Creation, higher voltage allows for higher top speed / more torque of the steppers ( Induces some problems aswell though ) What u need overall...