Separate names with a comma.
Some features disabled for guests. Register Today.
2021 Sept Update I hadn't been using my CNC Router very much mainly because the CNC foam cutter had kept me very busy. My 3d printer is used for...
This is a new build of a USB version of CNC hot wire foam cutter using 3d printer electronics? The picture below shows my latest RC models I’ve...
Thanks, Mark been a fun project to do with many more planes on my to-do list
rcKeith published a new build: Build a Hot Wire CNC Foam Cutter with inexpensive 3d printer electronics. Read more about this build...
Glad to help out. Software isn't as readily available for 4 axis CNC foam cutters without spending a fair bit of cash. I should know I did that...
You’ve built your 4 axis CNC Foam Cutter and now you need some software to generate g-code for that foam wing. If you can afford it then buying...
Here's my latest build with the Hot Wire Foam Cutter. Crashed my old wing so built a new one and its better than the old one. Check out the...
Hi David Can I do a manual zero of the Z axis once its done a move to the tool change area. I tend to use CNCnutz (Peter Passuello) method...
Thanks David that very thorough. I'm using Mach3 so I believe that works OK. I'll give it a try over the weekend. I'm trying to make some...
Been using sketchucam for a little while and seen the option when you save the parameters for tool change Not to sure how it works and wondered...
