Separate names with a comma.
Some features disabled for guests. Register Today.
what software tool chain are you using for your pictures?
MultiStep MultiStep Controller OpenBuilds MultiStep OpenBuilds MultiStep Controller
Dragon Rider CNC Dragon Rider Dragon Driver CNC Dragon Driver (Above substituting "Flex" or "Open" for "Dragon")
OpenBuilds Dragon Red Dragon Controller (Or black, green, whatever) OpenBuilds Flex Controller
Flex Controller Flex One Controller Openbuilds CNC Box
Dragon One Controller
Control (the Openbuilds controller) Or maybe "Control one"
Control Freak (This might be in the list already since I didn't read the whole list)
I was not planning on using a stepper because if I could get away with a reversible ac motor (driving two screws on either side of the lift) and a...
Yes, I was interested if the C-Beam or the belt driven methods could be used in any of my projects ... I was thinking of the lighter load ones ......
Yes, A scissor lift is the other way I am thinking of doing the 200lb project ... mainly because I'm having trouble finding a closed belt long...
The problem here is that I didn't state my initial question very well ... actually rereading its obvious that I'm asking wrong question ......
Ok I'll look at Unistrut ... I was just looking for a ballpark number or way to tell how much weight the screw or belt could hold ... I knew in...
Right ... I agree ... I'm not designing a CNC or 3d printer. I'm really looking into designing lifts for TVs or desks ... or for the 8mm screw...
Edit 11-5-15: just noticed I lost all the superscript formating ... just replaced with "^" ... I did do a little math but I'm not 1000% sure I...
