Separate names with a comma.
Some features disabled for guests. Register Today.
Its a nice design i would do this one if i could find a board exactly the right size. when do you estimate that you will start testing it
i am at the moment designing the case for the laser cutter. what should the minimum hight of it be
How are going to remove the exhaust? bigs fans above or enclosed with smaller fans
Do you know of anyplace you can get a metal sheet 1.6m long and wide or what did you use to put under the laser because i believe you would use...
what should i use that is cheap and in big enough size to be put under and on top of the laser. i will probably put acrylic window in it
i need something the contain the laser cutter that will easy enough to cut out a area for the fan i would have liked to use acrylic but it only...
So if I only plug up the positive and negative it will it run full power
Robert Hummel how did you connect the fans up to a power supply because it comes with a 3 pin connector.
[IMG] could someone confirm that LD+ and LD- is for the laser diode, input thats where the power comes in (i know thats obvious) and the output...
Is it possible to enlarge this to 1500 by 1500mm and also how hard will it be to make (will it be good as a first build)
You have a good explanation of what you will need but not how it goes together. How will you connect the laser throught the LD2X board(with the...
I have 1 last thing to figure out Power supply what should i use to supply power to the laser cutter as well as 2 DELTA AFB0612LB 6015 60x60x15mm...
i cant seem to find any smoke capsules do you know where i can get some
Hmm toxic fumes over populated area i dont think that would be a good idea. i know hardly anything about fume extraction so give me info about it...
well a room is not a good description a better one would be a metal shed in the back garden. for fume extraction system i think it would be best...
