Separate names with a comma.
Some features disabled for guests. Register Today.
I finally ran my first 'proper' Workbee job, making a clamping system. I am using Marius Hornberger's clamping design based on pressure exerted by...
Thanks for sharing this @fwm891, excellent guide and I will be following this myself shortly. For the Z axis would you say it would be possible to...
Hey folks, I hope all is well with your workbees. I am new to CNC and the Workbee is my first machine but have been reading up on it for ages...
Slowly but surely getting there, absolutely loving putting this together. It's my first CNC so I am taking my time and learning each step of the...
My 1m x 1m WorkBee arrived this morning, beyond excited to get my first CNC up and running. Thanks again Ryan! I am very very far behind where I...
Great, thanks Ryan. I ordered late on 31/10 so that makes sense
Hey Ryan, how are the full kit preorders coming along?
Great stuff Graeme, by the sounds of it we are both relatively new and will be building our machines at similar times. Iv'e quite a lot of general...
Oh a complete punt but you'll never know until you try. I actually have a load of ideas, I am learning Fusion360 in anticipation (this is my...
I'm in the same boat Graeme, kinda promised the better half I would make the money back quickly ;)
Pre-order just placed Ryan, just in time for the 10% off :D Very excited about this...
Excellent work Ryan, looks great. I'll be in touch in the coming weeks for a pre-order.
Hi Ryan. Sorry for threadjacking but do you know roughly when you guys will be stocking the C-Beam XL 'kit'? I may end up ordering the majority...
That's interesting... Also, to Wakez's point the trade off would be you can't use the kress as a 'normal' router. The below is an interesting...
I'm also based in Europe and will be going with the European equivalent of the DeWalt 611 which is the d26200. I was originally about to purchase...
