Recent Activity

Tim Schmidt replied to the thread OpenBuilds CONTROL v1.0.375 Finds wrong IP Address.

Thank You for the response. I had to reconfigure my network for a 2.4GHz network; my 5GHz network SSID is one letter off and I grabbed...

JustinTime liked Peter Van Der Walt's post in the thread Aftermarket tool height setter.

It is a SpoilBoard. Not a "i want to keep $5 worth or MDF pristine for life"-board lol. Its a consumable (;

David the swarfer replied to the thread Aftermarket tool height setter.

[MEDIA]

David the swarfer liked Peter Van Der Walt's post in the thread Aftermarket tool height setter.

It is a SpoilBoard. Not a "i want to keep $5 worth or MDF pristine for life"-board lol. Its a consumable (;

David the swarfer replied to the thread Stream G-Code from Home Shop.

no, 4 miles is too far, and as Peter said, never leave the machien unattended.

David the swarfer liked Peter Van Der Walt's post in the thread Stream G-Code from Home Shop.

Add an Interface to the CNC machine: docs:interface:start [OpenBuilds Documentation] so you don't need a PC there. 4 miles is far too...

Tim Schmidt posted a new thread.

OpenBuilds CONTROL v1.0.375 Finds wrong IP Address

Press Scan and Open Builds finds a controller 192.168.0.129 and stops. The controller was turned OFF; same results. The Controller is...

Forum: Control Software

Giarc replied to the thread Rotating the dxf x&y axis.

If using Vectric products, highlight the .dxf file then press either the 9 or 0 button. that will rotate it 45degrees each press if I...

Giarc replied to the thread Aftermarket tool height setter.

I zero at the machine bed so I pretty much only use mine upside down. :)

Giarc liked Alex Chambers's post in the thread Aftermarket tool height setter.

As @Peter Van Der Walt said, just flip your probe plate upside down. What version of Ooznest's firmware are you using? There should be a...

JustinTime liked Peter Van Der Walt's post in the thread Chamfer in openbuilds cam.

Lie about the endmill diameter and use a V-Bit (: Endmill diameter / 2 = offset Cut depth and offset determines how much you are...

JustinTime replied to the thread Aftermarket tool height setter.

My probe is always connected. I have a 'garage' for it to 'park' it when it's not in use next to the top of the spindle on the gantry....

David the swarfer replied to the thread OpenBuild Accro 1015 plotting inconstancy.

that pattern is mesmerizing

David the swarfer liked targz's post in the thread OpenBuild Accro 1015 plotting inconstancy.

So I finally figured it out, I had some play in my X motor pulley, It were invisible to me before I found a way to lock the motor....

David the swarfer liked Oleks Lytv's post in the thread multifunctional CNC machine.

This is right. Combining a CNC mill, laser device, and 3D printer can create conflicts in terms of speed, power, and accuracy, as each...