Separate names with a comma.
Some features disabled for guests. Register Today.
I tightened each v wheel hand tight. Then turned the eccentric spacer until the wheel couldn't move. I didn't know I needed to make them loose to...
Hey Jimmy! This is a repeat message on the other thread, but I wanted to post here for others in case they are facing the same problem. Looks...
Hey Jimmy! Looks like I found out what's causing the misalignment! Not the software, not the steppers, not the direction of cut, not the...
GRBL for both the old and updated CNC frame. I did use the old DRV8825 for the old CNC. This setup made perfect circles. The updated CNC used GRBl...
Thanks for the reply Jimmy! When I cut a circle and then cut another circle in the exact same position, it will not deviate, not even a tiny...
I am starting to think that the 20x80 t slot rails are racking. Is there a way to prove this? Maybe marking a spot shared by both rails and...
All tb6600 drivers have the same amperage 4.0a and steps 1/16
Hi Jimmy! I put my ox hybrid together and noticed that circles do not align over single passes (like engraving). I took my machine completely...
Kinda in the same boat! I've built a machine similar to the Ooznest that has the same exact problems! Circles do not line up and problem is...
Doing some research and found another builder suffering from the same issues I seem to be having trouble with: accuracy issue ooznest ox (what am...
Hello Tore! I seem to be having the same issue as you! Problem Engraving the Letter O or circles Were you able to resolve your problem? Please...
Great suggestion! Before I posted this problem on the forum, I swapped out each motor to find out if the problem would follow. No change in the...
Alright folks, I did a whole lot of testing the past two days. I will upload some pictures of the results when I get back home. But based from...
Agreed! Again, the Fusion 360 forum and you guys suggested the same thing! I am planning to do a set of circles with a single pass engrave and...
Hey folks! Tried it again with a post processor (based on Openbuilds actually) for Fusion360. Here is the link for a paper trail: GitHub -...
Hi Gray! Thanks for the suggestion! I believe it to be what Joe referred to as a g2/g3 interpretation issue. The Fusion360 folks were lead in up...
Hi Joe! Thanks for the detailed reply. I'm in no rush with this project. It's to house my electronics to protect them against the elements. I...
Hi Joe! Thanks for the reply! I measured my depth of cut and it came out to be .040" (1.01mm) deep. I CAMMed in Fusion360 for the v-bit to go...
Hello Openbuilds! I am in need of some higher level brain-power as I have run out of some a long time ago... Machine Specifications: OpenBuilds...
Wow, thanks for the quick reply Sonny! I will recheck the logic and wiring when I get back home! Here is a silly question but I think it needs to...