Separate names with a comma.
Some features disabled for guests. Register Today.
So I built an OX about 9 months ago. Mechanically it was straightforward and fun to assemble! Electronically, not so much. I started with Chinese...
I currently have a properly functioning Ox with a cheap chinese speed control managing my spindle. The unit comes with a pot which is used for...
Awesome sasquatch! Printed this afternoon and works beautifully. Went with 100% infill for stiffness and it's probably going to stay as my mount...
The stl files would be fine, and yes I'll be bolting it right to the 20/60 rail, no plate. Thanks again
sasquatch, as i'm still in the learning phase of 3d modelling and design, it would be most welcomed if you remixed one that would work with 20/60....
This was briefly mentioned about 40 pages ago but not much response... have any of you had to deal with noise in your limit switch wiring that...
My Ox is currently using the QuietCut 400W spindle with a sturdy but ugly DIY mount. I'm looking to 3D print a better mount. I searched...
For those of you interested, I contacted the seller (SMW3D) and they confirmed a mistake in shipping. They had been experimenting with various...
These were purchased from SMW3D, who i understand to be an authorized OpenBuilds distributor. They were ordered on the 9th of Feb, but i don't...
I have at least four wheels cracked, including one that cracked so bad a chunk of the wheel fell off. They are on all 3 axis with no pattern to...
Anyone have problems with the Extreme V-wheels cracking? I didnt think i had applied too much pressure to the wheels in adjusting the eccentric...
Ahh good point, Hadn't thought of that. Maybe I'll partially enclose them in shrink wrap such that only a slit is open for the slider.
Hi all, new guy here. Just about finished with the mechanical build of my Ox and started some of the wiring. One thing I debated was how to do...
