Separate names with a comma.
Some features disabled for guests. Register Today.
That is great yes Now I just need to have the laser beam a little thinner adn go into the hole . then copy the laser beam and rotate it down so...
where do you get the control board you show in the pictures what is it called?
Here is a sketch. All you should have to do is make a 30mm cube on top of the middle of the gantry plate. put a 15mm hole on the side the laser is...
I will take my time today and make a corel drawing with measurements so it should be real easy.
If you still don't get the general idea Think of it this way. Take a normal laser engraver its usually 2 rails parallel on the bottom holding a...
Hello and thanks for your offer. right now I would love to be able to just take that laser and make it go 90 degrees above the middle of the...
Here is a very simplified not to scale at all .gif to show you the idea just the laser heads would move back and forth (I know i didn't leave room...
Here is a newer version. I am not too good with sketckup I can explode things and move things most of the time but cant get anything to rotate in...
The C-beam the laser is mounted to does not move. Only the little 50mm black gantry mounted on wheels goes back and forth. So the only vibration...
here is a better version its all I can do as you see the table below will move and the laser Gantry will move.
I could even scale this up on one beam I just stack a second tube on top of one already and put a third gantry in the middle and just have the 45...
Here is what I managed to make up and it was painful. I know what I want to do the program just don't respond. I can use any of the gantries it...
Yeah that is my weakness I design in 2-d corel and cant make sketch up do anything even though he supplies all the parts lol. but yeah I have a...
Imagine a 1000mm length of C-Beam as a gantry above a cutting table. a Chinese laser tube is 50mm (2in.) diameter so rather than buying expensive...