Separate names with a comma.
Some features disabled for guests. Register Today.
I desperately need one of these adapters on my 1500x1500 OOZnest for a newly purchased Makita router. I'll actually buy two of them! Cost is not...
After reading many posts on the Vectric forum about using "machine bed" for z-zero to cut a profile all the way through the wood, and not carving...
Turned out to be a bad Xpro board
Craig: After posting this same thread on the Vectric forum, someone on that site suggested the same solution. I also used a 4' spirit level to...
I'm cutting out shapes from 3/4" Baltic Birch (with a black laminate on the face) for my sculptures, and getting uneven depth of profile cuts from...
Ryan: I purchased by replacement board from the Open Builds Store in the United States as I needed to replace it rather quickly.
Well, after trying all the helpful suggestions that everyone posted, it looks like the circuit board was the source of the problem. I did examine...
Neo: Yes I have noticed the lights on the board when moving the gantry manually. I have done that when working in my PJ's and wearing wool socks...
Neo: I didn't know that! Very interesting. I usually don't move it manually, but it's not out of the realm of possibility that I may have done...
Ryan: I don't think it's a Vectric problem because the repeating lines of question marks start as soon as I open the command tab on USG. This is...
Neo: I do have a wire running from my metal spindle mount up through my dust extraction hose and terminating on a screw on my electrical outlet....
I've been using Vectric Cut2D Pro since I started and have cut many jobs without a problem. If it turns out to be a GRBL problem, what do you suggest?
Scotty: Great idea! I hadn't thought of that! I do have an exposed controller board. I gave it a try by gently blowing some air in the controller...
Neo: I've checked the wiring with a tweezer by gently pulling on each wire. They all seem to be secure, but if I don't find a solution soon, I...
Well, the gantry controls seem to be working properly, so I was thinking that it wasn't a cable or a computer problem. I may have to rethink that...
Turning on verbose didn't have any effect. There was no additional info appearing on the readout and the repeating lines of question marks continued.
My 1500x1500 OOZnest has been working great for the past 6 months. Today, a weird little gremlin popped up on my Universal Gcode Sender screen....
I just wanted to give an update on my situation. I have now done 4 sheets of 4'x4' Baltic Birch, each sheet consisting of 2-3 dozen individual...