Separate names with a comma.
Some features disabled for guests. Register Today.
[MEDIA]
I've run the Black Box Controller from a Raspberry Pi 400 with 4GB of onboard memory and the Twister Operating System without any issues. There is...
Is there any hope of having something added to the Diagnostic Tab that shows the actual Voltage Draw by the Steppers. I realize that Marlin and...
I tried all of the suggestions that you listed and there was no improvement. And after checking for conflicts, I could find only one and I was...
I've noticed the same thing going from the G540 and its 48V compared to the Blackbox and its 24V . I have noticed that the acceleration seems to...
Well many thanks to you and Ian for helping me to understand the localhost:3000, as I'd love to go back to using my RPI 400 because it is a heck...
I wish someone would explain localhost:3000 to me so even a fool can understand it. Using an RPI 400 running the Twister OS, OBC runs like a charm...
I had originally built an OX but wasn't satisfied with the Belt Drive System and though I had seen others create Leadscrew Driven Y-Axis End...
It sounds almost like something is grinding, Have pulled it apart on the Y-Axis 4 times and can't seem to get rid of it. I'm thinking that it is...
Well I must be missing the message somewhere along the line. However, I turned Soft Limits Off and it did what it was supposed to do. The only...
When I home my machine with Limit Switch Pull Off set to 25mm. The X-axis machine head assembly is 25mm from the limit switched. The actual travel...
Todays error is as follows: Error 9: G-code locked out during alarm or Jog State G1 X19.939 Y35.8902 Z-2 Alarm-2 G-code motion targets exceed...
I had actually gone back to the GRBL Wiki and that's where I got into trouble. You see my pull Off for my limit switches isn't 10mm but rather...
That's just it, I've checked the settings in GRBL against what I have for the spoilboard and they're exactly the same. Yet I am still getting this...
Okay on that one. Thanks.
If I could use the controller in offline mode I could easily send you what you request, but alas I'm sending these requests from a separate...
I've already created and run projects, but I needed to resurface my spoilboard to get it equal side to side. When I click on run after using the...
Almost there, now when I click run after Zeroing everything and starting my Router 11. Which of the 3 options do I use after I click Run? I got it...
I'm going to go through each of these steps one at a time to make sure I didn't miss anything. I will let you know what becomes of it.
I was thinking that when I lowered my Z-Axis assembly I screwed something up. On my CBeam XL I have the bottom of the Z-Axis 2 inches above the...
