Separate names with a comma.
Some features disabled for guests. Register Today.
*****UPDATE****** I would like to thank everyone for there help and to the GREAT People at the Opebuilds store for there quick shipment of my...
David, Thanks for the explanation! I was researching it after I ordered my backlash nuts and ran across the same site you referenced. Thanks...
David, Thank you for this information, I also noticed that my Anti - backlash nuts seam to be worn and cannot adjust them to work properly so I...
UPDATE Gary, Applied your suggestions and things got better still some stalling but not as bad as it was. I forgot to open my work shop up so...
Gary, I will try Jonathon's recommendations first and see what the results are then will try your suggestions and see what happens. Thanks for the...
Jonathon, Thank you for the advice I will try your suggestions when I get home tonight and will update with results.
Hello, I cant seem to figure the GRBL Settings out! My Set up is as follows, Open Builds C-machine with three Nema 23 stepper motors 1.8 deg. 2.8...
HMMMMMMMMMM 3 pounds 6oz
Mark, The software side is really only an issue if you chose as I did to use open software! I used a raspberry pi with a pi alamode and a CNC...
FatGut published a new build: MY experience as a first time introduction to the CNC world! Read more about this build...
I ordered the "C" machine from OpenBuilds and and began assembly as per online video instructions! Build went fairly easy due to exceptional video...
OB-Jolt
Postulates"1" (To draw a straight line from any point to another)
Step-n-Time {From Mary Poppins}
HEP-C Its infectious!
HepC (High end professional controller)
HepCNC (High end professional controller)
HEP-"C" (High end professional controller)
Sonny, I wish I would have seen your initial post on the PI and Bcnc!! After having built the C-machine I got to admire it every day and watch it...
