Separate names with a comma.
Some features disabled for guests. Register Today.
I used to use an xpro. I had 2 version 2s and a version 3. They all died. Do yourself a favour and get a better controller. The open builds...
You can run a fan off the fan header on the board
That’s not old at all. Speak to the people you bought it from or Mike from Spark Concepts and see if you can get a replacement. My supplier...
I had a new one do this but with the cloned y axis. For whatever reason it’s dead. You need a new one. How long have you had it?
Cool. An ATX is a bit neater though.
I’ve bought an ATX PSU and have a RN42 BT module too. I went down the Xbee route but it stopped working. I got the Bluetooth connected with the...
On my v 2 I had an issue where one of my y axis motors would just stop working randomly. Replaced the board all was fine. Msg spark concepts. He’s...
Firstly check you z probe wiring by just getting the ends of the wires and touching them together and seeing if it stops.
So I am posting those here because we all have the same board even though it’s only because of the board and not the ooznest kit. I’ve set up...
Try BCNC then and see if it does the same.
Try generating the G code from exactly the same vectors with another program like EstlCAM and see if it makes a difference and run it through UGS....
You could try downloading ESTLCAM. It uses its own firmware. The software is free to use for a trial and as a CAM program. It’s also endorsed by...
I am not a fan of UGS. It’s ok but not as feature full as BCNC, isn’t as stable and isnt as configurable.
1. As mentioned you don’t want to take the router off. Just buy another one for £150. 2. Yep! 3. I haven’t experience. You may have to mod...
I wouldn’t even bother trying to do all the maths, it’s just one more thing to worry about. Buy G wizard for a year ( you probably won’t need it...
I am Sounds like the ratio is out. I am not a huge fan of UGS or UGS platform. I initially thought it was one of the most stable senders but I...
I reckon that should work. It won’t do it any harm. It’s only to trigger a signal so the current draw on the xpro terminal will be minimal....
As I said. Your ramping setting could be too sharp. So you are going to in too deep and sharp when you start cutting which could make it lose...
You need a very rigid machine to do climb cuts. That’s one thing about the ox there is a bit of flex in the gantry and z axis of you put it under...
Acrylic isn’t that hard. You should be cutting a max depth of about 1.5mm per pass. If you reduce the depth per pass you should be able to...