Separate names with a comma.
Some features disabled for guests. Register Today.
indeed. Indeed. I need to set the feed rate rather fast. I do not see burn marks or anything, but still the RPM is too high, so I need to get...
Hi Paul, I wonder if your problem is related to the problem I am facing and investigating. In my case, the router (a trend T4) must be...
Indeed, that works, thanks :thumbsup:
I am a bit confused about the use_pocket_cw and use_plunge_cw settings. They seem to be related to climb milling, but do not seem (and the name...
Have a look at page 40, there are pictures of 2 options there.
I see, interesting So, this means that one does not only has to have an additional driver but also a "channel" on the control HW/SW (say GRBL,...
Open-source code like grbl could be adapted. Alternatively this could be very nice little arduino project for a standalone device. This has the...
@Robert : it is grbl... @Hokkaju and @Mark : indeed $1=255 for GRBL 0.9 works fine, as soon as the board is powered the motors are active....
I have the same issue, and I think Mark mentioned before as well. What I do for now is hit the start button and while the machine is raising the...
Built an OX CNC machine and perfecting it
Not so confident that I fully understand the problem you describe. What I have found is that in some cases parts are not plotted. In one case I...
I had the same issue; they where 6mm. Not sure if I miss ordered or not. I drilled the holes to 8 (first 6.5, than 7, 7.5 and 8) and that worked...
Indeed very interesting, thanks.
I am confused about the current needed to drive stepper motors. I currently use a gshield. The are pots to control the current for each stepper, I...
Aha! Interesting :)
The selection and setting up of HW & SW to control a CNC machine would be a great topic for a WIKI I believe. Now all interesting information in...
Yes, ok, try G01 F200 first, this will specify the feedrate for G01 Frederic
I strongly agree :thumbsup:
It means that the limiting switches where triggered and GRBL is in alarm-state. No commands will be accepted. Do you have switches installed? If...
I switched to 0.9 a few days ago. It seems that GRBL controller (at least the one I use) does not seem to be compatible with GRBL 0.9. When moving...
