Separate names with a comma.
Some features disabled for guests. Register Today.
Thank you guys for the help by the way I do very much appreciate it
2.5mh on these it was stated in this thread no higher than 2mh so will that be an issue
So according to that data sheet I should be good to run these motors with the openbuilds set up?
these are the kits I bought spindle Amazon.com Nema 23 (doesnt give me much info as far as voltage and current goes) Amazon.com
I bought the power supply from open builds as well
Thabks for the reply i am going to check this out now and Sorry I meant the cnc interface touch not the touch plate.
Maybe I did not look hard enough but where can I find information on how to hook up and run the x32 and the touch as I have built my own cnc...
So I just made the purchase today of the blackbox x32 motion controller and the interface cnc touch. Where do I start on learning how to use this...
I started this printed build about 7 years ago and then about half way through it got pushed to the side for several years I have recently...
Any specific belt you would recommend?
So I am building this machine in attached pictures using aluminum extrusion. I had a guy cut out the brackets for me at work. The machine is 8ft...
I haven't made it that far in this journey yet lol. However I have parts and plans for a bigger machine with nema 23 motors that I will have to...
Also here is a pic of current set up
I attached a notepad version of the configuration h file with feed rate and acceleration settings I tried from other people who are trying to...
Wiring is good. I will play with the speed and acceleration settings today and see what happens. Any idea around what number I should put in there...
Can someone please provide some assistance. I recently built a cnc router I am using ramps 1.4 arduino mega. The issue I am having is I was using...
The microstepping I haven't got to play with yet but will be at some point I do however know that this is also something that could cause the...
How is your configuration h file set up? I'm surprised more people have not commented on this as I'm still very new. One of the other problems I...
If it's possible (do you have another ramps board on hand or able to obtain a second one just in case) try using another ramps board I am in no...
I ran into a very similar problem about 2 weeks ago except mine was only doing it on the z motors. I will mention it am in the middle of building...