Separate names with a comma.
Some features disabled for guests. Register Today.
Is there a place on this forum to sell your older open builds projects?
For your steppers check to see if you are running enough current on your driver's. I haven't used the xpro but pretty sure there is an adjustment...
Probably cheaper to ship it
You can invert motor direction in the grbl firmware.
7lb 8oz
So I don't use either of those programs but whatever you are using as a driver/controller board is set to some amount of micro stepping...you need...
I am not using limit switches. But the mechanical should be fine. Hook up is pretty easy and you should be able to find plenty of info on the...
Z touch plate is nice but like you said you can do it yourself for now. With the DeWalt router the lowest speed is still somewhat high for 1/4"...
Precision solid Carbide Tools for CNC Woodworking and Metal Forming This is a great site for higher quality collets. Not sure if they ship to...
Could just order 1000mm cbeam and a new lead screws also that would give you plenty.
The issue with the Y axis is the plate is pretty big. So you could add more spacers to rise it up from the wheels but it may cause you some...
Looks great. I have been meaning to update it a bit. Mine is a tight fit and the corner issue was brought up by Kyo. Mine worked good enough and I...
Not sure if it is correct or not but my calculations come up with...and this assumes the screws are needing 199.1 steps per mm with 1/8 micro...
Thanks sir :)
Do you also notice they come back into round after a bit of run in? Or once the damage is done it's too late?
Question: I saw a post that says the correct steps per mm for 1/8 micro stepping should be 199.1. I am using Estlcam. In the set up screen it...
Was finally able to get my double wide plate installed on my z axis, and noticed that the action on the z was a little rough when moving the plate...
You can also try Estlcam, which has a controller built in. It works well. I have used it and it programs your Arduino for you...it says it is...
To save you have to double click the parameter you want to change. You can only do one at a time.
I found my C-Beams were not perfectly square at the ends so setting a level on top of the z caused me a bit of grief. The beauty of cnc and...