Separate names with a comma.
Some features disabled for guests. Register Today.
Anyone know the solution to the latest changes to Fusion 360? I can't seem to enable cloud config on my system. Is there a new procedure? Thanks.
Thanks, went through the video. Sadly it doesn't really address my issue. Can you have a look at the attached video and comment on the cause and...
For want of a better description, how do I tweak the settings for the motion of the tool head from origin to cutting point? I have managed to...
Looking at the model i am working with, i might have hidden an empty offset plane which i think might have created a empty void which created an...
So the main problem lies in the Fusion setup? Am pretty confused at the moment. Trying to think of where to find the source of the fault. Thanks.
This is the second time its happening to me. I like the software but its a tad temperamental. The current situation follows. I am using Fusion...
The Y is at 90 but the router is off by a few degrees. Do you use shims? Am referencing it off a spirit level.
Well my Cbeam is not 100% true. Will using the flattening bit with the Openbuild Control address this? From what I presume, by levelling the...
What happened was the mill got too deep into the wood and started burning. Was using a non caustic oven cleaner. : ) It removed the burnt bits.
What is the best way to clean bits that have a bit of dark burnt stains? Am soaking the bit in oven cleaner overnight.
What are the recommended free solutions to generating 3D Toolpath? I am exploring the limits of the CBeam machine, Especially in milling complex...
Not recovering but sending a signal to kill all processes. Like this example Google Image Result for...
Am in the midst of completing the control housing for the Arduino Uno and the Stepper Drivers. I want to install an emergency cut off switch but...
Well, I agree with you on that. Even if I stick to a single mill. From my observation of SketchUCam. The limitations are that you need a...
I am just starting to try out the Cbeam proper. I have a few nagging questions keeping me awake. For different milling actions to take place,...
Does anyone get as confused over the units of measurements used for Cbeam? Is it in mm or inches? Admittedly I am using Sketchup with SketchUCam...
Am using a CBeam.
After more testing. It appears that the simulated is flipped when it is sent to the machine for its cut job. How do I set it up so that the job...
Am having some difficulty getting the machine to work properly. Am trying to set it up for its first actual cut and it doesn't seem to want to...
The fix was actually pretty simple. Had to rotate the board. :) Been staring at the problem for too long and the solution was staring right at me.