Separate names with a comma.
Some features disabled for guests. Register Today.
I had a black box quit on me and I got a new one, moved all of my wiring directly from the old black box to the new black box. Everything works...
I think I actually fixed the issue with the Z axis. I took the motors of, pulled the lead screws, brought the gantry up to the bump stops,...
Yeah, I switched the wiring and the motors, same side just bogs down and stops.
I am just about to the point of boxing it up and sending it back, I can't get anybody on the phone to help, and it takes 24 hours to get a...
No binding, I re-tensioned the lead screw, but the Y2 motor just grinds while the Y motor moves the Gantry, I fear it will bend the Frame. But...
Here is my GBRL Backup....
I have re-wired the motor, I have switched the Y and the Y2 motors on the black box, and it produces the same results. I don't know how to check...
Mine does the same thing, the Z axis drags on one motor throwing the gantry out of alignment, I have checked the square, all the motors are wired...
So, I still have to shuttle USB drives to the Interface if I don't use control? What's the point of having the WIFI on that machine if you can't...
Ok, then how do I transfer my g-code to interface from my pc without being able to connect to it? I have tried to use the UNC path to connect to...
Just an update, I cannot telnet nor ssh to the ip indicated on the Controller screen either.
I cannot connect to the IP address indicated on the controller screen either by http or https.
I got it resetting with the SSID and PSK saved, and was able to get the latest firmware installed, but I still cannot get a connection to the...
Finally got the system to connect to the network, I can ping it from my computer, but I can't get it to connect to the Control Software, I scan...
It's got me perplexed. I can get this little black box attached to my WIFI network, but every time I power off the X32, and it reboots, it tells...
I am so torn, to drill, to tape or to vacuum. I think I am going to drill and tape... Vacuum systems cost twice what my Lead 1515 cost. CA Glue...
I have seen a couple of other machines like the X-carve and the Shapeoko that have those inserts. I actually thought about trying that. I wonder...
Has anyone tried to set up a vacuum table on the Lead 1515 Machine? I was just sitting here pondering the question and I could not find any...
Oh, and is anyone else running multiple Z gantries on their machines? Crash5050
With the way the LEAD1515 machine is set up, using 4 separate "quads" for the spoil board, has anyone figured a way out to do a vacuum hold down...
