Separate names with a comma.
Some features disabled for guests. Register Today.
Hi All! A long time ago, I used to build CNC machines for a large Carbide manufacturer. It was fun and when I look back, probably the most fun...
Thanks! I use many different suppliers. Openbuilds for some. Ali Express is a big one for me. Ebay, even Amazon. a lot of the parts I need are...
Hey Mike, The table top is 48" square. There are several inches of overhang along the Y axis in the plus and minus directions that overhangs the...
It's about 48 x 54 overall. I need the overhang over the 48 inch top for the rails. The cutting area is 40 X 46.
Hey Gary, No, not yet. I have the z axis together but i need to make a mount point. Also, I have all the limit switches and wire management work...
Yes, I run a 36 volt power supply to make up for the lower current flow. Power = Current x voltage. if current is lower you can up the voltage a...
Do you meant the actual platform? I would the wheels that lock if you do so your machine doesn't dance! As far as if that is bad or not, I...
Dual belt. Here's a link to the motors. Nema 23 CNC Stepper Motor 2.4Nm(340oz.in) 1.8A 23HS41-1804S - US$ 28.48. The CNC board has a clone...
Thanks! Someone else told me that as well. When I clicked on it and it downloaded and ran which isn't what I wanted it to do as well. I will need...
I have pretty much the same attitude about taking chances. Some of the best ideas of come up with were after I failed doing something and figured...
Thanks, Ironically it would have been way easier if the machine was already completed. I guess it is the old chicken or the egg scenario. :-)
Richard Long published a new build: This build focuses on the basics to provide a good foundation to further enhance the ability to achieve...
