Separate names with a comma.
Some features disabled for guests. Register Today.
Hi everyone, I'm a cabinetmaker from Denmark and I'm pretty new to the world of CNC. I'm just about to order a LEAD 1515 since I'm in Europe I'm...
Hi all, I’m just wondering if someone could help? I have my workbee setup with an Xsy-at1 vfd and an air cooled spindle. My dust extractor is...
Hi, I can flash GRBL 0.9 to my xPRO just fine. In fact it has had that on it for 2-3 years, and flashing it again works fine. Now I want to try...
Hi all Has anyone got any setup guides for vfd’s and the x-pro v4. Finally decided to ditch the dc motor for something with a bit more power thanks
Don't know if it's an issue with CONTROL, Grbl or my xPro v4, but there's a few problems I've ran into a few times randomly. - My macbook pro...
Aloha Guys! So i rebuild my C-beam into a 1000mmx500mm workbee. The Bee is powerd by the cnc xpro v3 and a ATX power supply. Now it worked ok...
Hi Just finished a second small CNC Router for a friend and wanted to run a couple of jobs before I get him to pick it up. For some reason I can't...
Hi guys/gals, I've got an issue with an OX CNC. Used to work fine, then it didn't! Y Axis (Long Axis with Slave Motor) stops working and X axis...
Hello fellow open builders, I am having an issue with my OX Router and getting it to run with UGS. This system was working fine around 2 months...
Hi everyone I start off by saying that i'm just an enthusiast without much knowledge of electronics and kind of got stuck. I'm using NEMA 23 High...
I am planning to build a laser cutter using a 100W CO2 laser and an xPro board. So far, it seems like it can control the laser's power with PWM no...
My 1500x1500 OOZnest has been working great for the past 6 months. Today, a weird little gremlin popped up on my Universal Gcode Sender screen....
I have recently purchased a ooznest cnc ox with xpro controller, it was working perfectly. Unfortunately the xpro port broke, due to straining of...
Hi all, I have recently assembled a grbl controlled, Ox router CNC, using an xPro V2 controller (from Spark Concepts) and ChiliPeppr as a gcode...
I am having problems with the cloned y axis dropping off randomly, this is a new ox build and ive been trying to work it out and am yet to do my...
Hi guys and gals, Does anyone use MatLab for motion control? Bit of context: I'm trying to build an open source microscope/stack and stitch...
Hi guys! I've just finished my build OX build with a CNC Xpro v2 board and now i want to test it. I've messed around in UGS and manually it moves...
UPDATE: I received my replacement board today. I plugged everything in and fired it up. Working like a champ! I haven't had a chance to actually...
Does anyone know if the xPro can be used to run external drivers. I like the board well enough but I will need more current capacity than what...
Hi All I have started the mechanical build of an Ooznest OX CNC and getting to the point where I need to commit to my choice for a controller....