Welcome to Our Community

Some features disabled for guests. Register Today.

2 color for newbies

Discussion in '3D printers' started by snokid, Jan 28, 2017.

  1. snokid

    snokid Journeyman
    Builder

    Joined:
    Oct 11, 2014
    Messages:
    335
    Likes Received:
    104
    I figured I would post this here didn't use an openbuilds 3d printer but this can be done pretty much on any printer. Might help some just getting started.
    Shows from start to finish how to design a key chain in tinkercad, slice it in cura, figure out where to do the color change and how it all comes together.

    I want to make videos to help people, my first ones sucked I think I'm getting a little better!?!
    more to come openbuilds stuff soon!!!

    anyways take a look.
    Bob

     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice