Welcome to Our Community

Some features disabled for guests. Register Today.

Amazon Special

Discussion in 'Other Builds' started by Linkreincarnate, Feb 10, 2017.

  1. Linkreincarnate

    Builder

    Joined:
    Jul 17, 2016
    Messages:
    2
    Likes Received:
    0
    Linkreincarnate published a new build:

    I have parts that are apparently not suited to a cnc router or a 3d printer. I am still trying to figure out what to make out of what I have. I was wondering if someone could take a look at my specs and tell me if it is better to go for a large scale 3d printer with these parts or a CNC plate maker. I already have a 3d printer so I'm leaning towards plate.

    Read more about this build...
     
    #1 Linkreincarnate, Feb 10, 2017
    Last edited: Feb 10, 2017
  2. Rick 2.0

    Rick 2.0 OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Dec 20, 2013
    Messages:
    2,855
    Likes Received:
    1,525
    Truly I'd add another stepper motor and stepper driver and build a CNC router with what you have. It'll look a bit Frankenstein but if it does the job who cares.

    As for the 618, that's way too much motor. If what you have won't cut it, go with the 611 or the little Makita.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice