Welcome to Our Community

Some features disabled for guests. Register Today.

finishing pass sketchup/sketchucam

Discussion in 'CAD' started by snokid, Nov 9, 2014.

  1. snokid

    snokid Journeyman
    Builder

    Joined:
    Oct 11, 2014
    Messages:
    335
    Likes Received:
    104

    if you watch at 36:45 the machine cuts a rough cut then comes back and cuts a finishing pass
    Is there a way to do this with sketucam?
    I was thinking you could tell it you had a .248 bit then go back and tell it you have a .250 bit.
    must be a better way.
    sorry if this is easy newbie here...
    Bob
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice