Welcome to Our Community

Some features disabled for guests. Register Today.

How to mount Nema 17

Discussion in 'General Talk' started by Adam Filipowicz, May 28, 2017.

  1. Adam Filipowicz

    Adam Filipowicz Veteran
    Builder

    Joined:
    Dec 21, 2014
    Messages:
    182
    Likes Received:
    49
    I need to figure out a way to mount a Nema 17 to a 20x20 Vslot Gantry plate using only openbuilds components

    It doesnt have to be centered, like shown, But i would still like access to the M5 screws if tightening is needed. Nema 17 cant be angled either

    I would appreciate any thoughts or ideas.
    nema17vslot2.JPG
     
  2. Grantman

    Grantman Veteran
    Builder

    Joined:
    Apr 10, 2017
    Messages:
    68
    Likes Received:
    30
    A second plate that has a register for the stepper and additional holes in the corners, and four standoffs/spacers of appropriate length. Make a box that the motor mounts inside of.
     
    #2 Grantman, May 28, 2017
    Last edited: May 28, 2017
  3. Grantman

    Grantman Veteran
    Builder

    Joined:
    Apr 10, 2017
    Messages:
    68
    Likes Received:
    30
    Could also be done bolting two 90┬░ mounts together.
     

    Attached Files:

  4. Rick 2.0

    Rick 2.0 OpenBuilds Team
    Staff Member Moderator Builder

    Joined:
    Dec 20, 2013
    Messages:
    1,399
    Likes Received:
    557

Share This Page