Welcome to Our Community

Some features disabled for guests. Register Today.

LinuxCNC stepconf

Discussion in 'Control Software' started by ChadRat6458, Jan 27, 2016.

  1. ChadRat6458

    Builder

    Joined:
    Dec 10, 2014
    Messages:
    93
    Likes Received:
    24
    Can anyone post the numbers or screen shots of what they used in the stepconf wizard for the y, x, and z axis for an Ox router setup? Thanks.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice