Welcome to Our Community

Some features disabled for guests. Register Today.

Matt's Ox

Discussion in 'CNC Mills/Routers' started by Matt Nelson, May 29, 2016.

  1. Matt Nelson

    Builder

    Joined:
    May 15, 2016
    Messages:
    4
    Likes Received:
    20
    Matt Nelson published a new build:

    Read more about this build...
     
    Joe Santarsiero likes this.
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,742
    Likes Received:
    2,407
    Great looking OX Build and Build post @Matt Nelson :thumbsup:
    Thank you for sharing the details, these will be a big help future OX builders!
     
  3. Julius

    Julius Well-Known
    Builder

    Joined:
    Nov 13, 2015
    Messages:
    193
    Likes Received:
    61
    Before you start cutting too much I recommend you swap the Z nut out with an anti backlash one, and run dual belts. ( have a spool here if youd like some)
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice