Welcome to Our Community

Some features disabled for guests. Register Today.

Ideas for aligning a pulley

Discussion in '3D printers' started by Adam Roberts, Jun 23, 2015.

  1. Adam Roberts

    Builder

    Joined:
    Jun 17, 2015
    Messages:
    13
    Likes Received:
    1
    Hi everyone,

    My first post in the 3d printer section! I have been working on a design using nema 23 motors, since I can find models that have very small step angles (0.45 degrees!).

    I have tried several ways of integrating these larger motors into a frame, and I have a design. I was hoping someone more experienced could take a look and see what they think.

    The problem is this:
    The idler wheel is slightly out of alignment with the motor pulley, due to the v slots not being at the same height as the motor shaft. I cannot think of a way to fix this.

    I've uploaded a photo, as well as a STEP file so you can take a look.
    Any ideas are welcome, thank you!
     

    Attached Files:

Share This Page

  • About Us

    The OpenBuilds Team is dedicated helping you to Dream it - Build it - Share it! Collaborate on our forums and be sure to visit the Part Store for all your Building needs!
  • Like us on Facebook

  • Support Open Source FairShare Program!

    OpenBuilds FairShare Give Back Program provides resources to Open Source projects, developers and schools around the world. Invest in your future by helping others develop theirs!

    Donate to FairShare!